I just spent the last two entire days at the workshops sanding the two parts of the mold with three differents grains of sand paper and correct any anomalies with resin filler. However, the molds are now finished !
I had to reinforce the inner structure to resist to the vaccum pressure during the forming which took me also quite a while but at 2pm this afternoon, the two parts of the helmet were now formed in the 3 mm width sheet of plastic. I'll have to re-cut them, sand them, glue them with epoxy, re-sand and finally paint them with at least 2 layers and a maximum of.. 6 layers which I'll try to avoid if possible..
Showing posts with label workshop. Show all posts
Showing posts with label workshop. Show all posts
Helmet Design - Part 4
0
comments |
This entry was posted on Monday, 9 May 2011
Another day at the wood workshop at CSM. I finished the 2 parts (upper, lower) of the prototype made out of cardfoam. It had to be very precise because the vaccum forming process doesn't allow any mistake, even a millimeter, into the wooden mold. I cutted every single piece of the helmet into 16mil MDF and I started to sand each side at the right angle to assemble them. This was super difficult to measure and to sand hopefully CSM has great facilities, ressources and staff and I'm quite happy about the work I've done (thank you digital angle measurer). I hope I'll have enough time to finish to sand each piece of wood and stick it together before the end of the week.
Vaccum forming will definitely be the easiest part of the work.Workshops are back!
0
comments |
This entry was posted on Tuesday, 3 May 2011
The final term start today, the wood & plastic workshops are re-opening after a long month being closed. I started cutting the wood mold for the vacuum forming from the very precise cardfoam model. Next post this week.




