Helmet Design - Part 6

I just spent the last two entire days at the workshops sanding the two parts of the mold with three differents grains of sand paper and correct any anomalies with resin filler. However, the molds are now finished !
I had to reinforce the inner structure to resist to the vaccum pressure during the forming which took me also quite a while but at 2pm this afternoon, the two parts of the helmet were now formed in the 3 mm width sheet of plastic. I'll have to re-cut them, sand them, glue them with epoxy, re-sand and finally paint them with at least 2 layers and a maximum of.. 6 layers which I'll try to avoid if possible..